Skip to main content

What kind of battery does a 2016 Jeep Cherokee key fob take?

What kind of battery does a 2016 Jeep Cherokee key fob take?

CR2032 battery
Insert the new CR2032 battery, making sure the negative side is down. Put the circuit board into the keypad, then put the keypad into the key. Finally, snap the two key fob halves together.

What battery goes in a Jeep key?

Key fobs use small coin-type batteries. The number of your key fob battery will be printed on it. One common key fob battery is CR 2032. Depending on your Jeep model and year, your key fob could use a CR 2032, CR 2025, or a CR 2450 battery.

What kind of battery does a Jeep Grand Cherokee key fob take?

Take a new CR2032 battery and click it into place positive side down. Finally, click the two halves of the device back together. That’s all it takes. Well done!

What size battery goes in a Jeep?

In the case of the 2016 Jeep Wrangler, the direct-fit replacement battery is a Group 48 (also referred to as an H6 battery) and OPTIMA battery makes a direct-fit replacement H6 YELLOWTOP.

Can you replace battery in Jeep key?

Steps for Replacing Your Jeep Key Fob Battery Use a small flathead screwdriver and press it into the seam of the key fob near where the keyring mount is located. Use the screwdriver to pry the key fob apart at the seam. Take out the battery and swap it for a new CR2032 battery.

What kind of battery does a 2015 Jeep Cherokee key fob take?

In this video I will show you how to change the internal battery in a Jeep Cherokee key Fob. This key Fob was used between 2014 and 2021 and runs on one CR 2032 battery.

What battery does a 2017 key fob take?

Usually, you’ll find a CR2032 battery which you can find all over Watsonville hardware stores and big box retailers. There are normally below $5 at most places. After getting your Toyota key fob battery replacement, place it in your key fob case and close the key fob.

How do I program my 2016 Jeep Grand Cherokee key fob?

Insert the key fob programmer into the OBD/DLC port under the steering column near the pedals. On the key fob, press the LOCK and UNLOCK buttons simultaneously for 3 seconds. Press the UNLOCK button for 2 seconds. Repeat step 6 and 7 for all additional fobs.

What type of battery goes in a Jeep Cherokee?

Many newer Jeep Cherokees, including models like the Jeep Grand Cherokee, often take a Group H7 battery, which is commonly known in the industry as a “DIN” fitment.

How much is a key fob battery cost?

Generally, these batteries cost $10 or less, though some fobs require two batteries. Battery specialist shops and dealers will often replace the battery for free since it only takes a moment or two.

What battery does a 2014 Jeep Cherokee key fob take?

Insert the new CR2032 battery in the key fob, facing the same direction as the old battery (positive side down). The two halves of the fob should easily snap back together. That’s it! You’re done!