What is Ma dot2?

Table of Contents

The dot2 core is a compact lighting console designed for small to medium sized productions up to 4,096 control channels. The easy to operate dot2 software is available in multiple languages and provides onboard Help and Direct Hints to guide a new user to operate the console to its full potential.

Does DMX need a terminator?

First, you need a terminator for the DMX signal. Without a signal terminator, your DMX signal will reach the end of the line, and bounce back like a rubber ball off a wall. This is known as a reflection and it will interfere with your DMX signal.

Can you use XLR instead of DMX?

Yes, it is possible (but not advised) to use XLR cables for DMX connections. DMX has a higher impedance (110 ohms) than XLR (75 ohms). This means that XLR uses different signals than DMX is built to handle. An XLR cable can transmit a DMX signal, but not very well.

Can you run DMX over Cat5?

It’s generally acceptable to run DMX over Cat5 or Cat6 cable for up to 1000′. However, it’s important to remember that network signals can only travel 300′ – so if you go above that limit, label your cables carefully – computer networks will not work reliably at these lengths!

Can I use XLR cables for DMX?

How many types of DOT2 are there?

dot2 XL-B dot2 F-wing dot2 B-wing dot2 Node4 dot2 3D dot2 onPC Sitemap Terms & Conditions Imprint Privacy Policy IP Contact MA Merchandising

How do I contact MA Lighting International?

How many DMX channels does the DOT2 onpc offer?

Additionally the dot2 onPC offers free to use 512 DMX channels since software version 1.2.2.8. The dot2 onPC software incorporates all functions of a dot2 console and provides its full potential on a PC.

Can the DOT2 onpc be used off-line?

It can be used for off-line editing or as part of a back-up strategy. Additionally the dot2 onPC offers free to use 512 DMX channels since software version 1.2.2.8. The dot2 onPC software incorporates all functions of a dot2 console and provides its full potential on a PC.